6565656565
Authorized Distributor of The Restorer tool
Select Page

FREQUENTLY ASKED QUESTIONS

Product Questions
What vac adapters work with the Restorer?
3-Piece Hose Diameter Adapter Kit for RIDGID Wet/Dry Vacs | Dust Right Universal Small Port Hose Kit | Bosch VAC003 Airsweep Vacuum Hose Adapter | 1″ Hose end cuff fitting 164236 Woodcraft
How much does it weigh?
4.5 lbs.
Does it come with anything?
Yes the starter kit comes with two 60, 80 & 120 grit sanding sleeves. The full kit comes with additional accessories; one rust/paint removal roller and two abrasive sleeve; one medium and one coarse.
What does the tool actually do?
It sands wood and removes rust, paint and stain from wood, metal, concrete and fiberglass.
How does the dust port work?
You will need to attach a shop vac to the rear dust port of the restorer in order to suck up the dust or debris created when using the tool.
How safe is it?
The restorer is very safe. 80 percent of the sanding roller is covered by the roller housing.
Is it hard to use?
No actually it is very easy and safe to use. It is light weight and very simple to operate.
How long do the sanding sleeves last?
Approximately 100-250 sq ft worth of sanding depending on the application. If you are removing stain then probably 100 sq ft and if you are just sanding then up to 250 sq ft.
How to you change out the accessories?

Unlatch the front hasp leaving it attached to the cap.  Unlatch the rear hasp completely from the cap.  Lift the cover and flip it towards the front of the tool then the roller just lifts up and slides out.

How do I change the sanding sleeves?
You hold the roller in one hand and then press the center of the roller with your thumb of your other hand and then rotate the sleeve off compressing the rubber roller flaps as it rotates.
Do the rollers need to go in a certain way?
The restorer is designed to only allow the rollers to go in the correct way. See the notes on the rollers to show the direction to install it.
Can the restorer gouge the surface?
Only if held in place for an extended period of time while pressing down.
Usage Questions
Do I need to use two hands?
Not all the time, but depending on the job you may need to in order to maintain control of the tool.
Am I supposed to press down on the tool to use it and if so how hard?
No. Let the tool weight do the work for you. Just maintain a firm grip on the handle(s) during use.
Is it better just to move the tool forward or forward and backwards during use?
It is best to move the restorer back and forth evenly and consistently that will give you the best uniform results.
Do I need to connect it to a vacuum?
No you do not, but it helps the accessories last longer by vacuuming the debris from the roller as it rotates in the chamber and keeps the work surface cool by continually drawing fresh air over the surface.
Can I use it vertically to sand a fence?
Absolutely. The restorer handle is designed specifically for that purpose.
Can I use the Restorer on wet surfaces?
It is best to use the Restorer on dry surfaces only. If not you run the risk of electrical shock, clogging the dust port and getting water in the bearings.
How often should the dust port be cleaned out?
The dust port should be checked before and after every time it is used to assure the vacuum collection is working properly.
What should I clean the dust port out with?
A soft bristled tooth brush works great for removing light debris that may be caught in the chamber. It is also best to remove the roller so that you can access both side of the dust port.
What is the best way to store the restorer?
It is best to place the restorer on the nose or the front handle of the tool. It will keep the roller from making contact with any surface.
Do I need to oil and gears?
No the restorer gears are greased at the factory and sealed in the gear housing.